Maredes homeRequest a water review
Menu

Water filtration and reuse for hotels

Laundry, guest rooms, grounds and kitchens each use water differently. A hotel review measures each one, then puts the cheapest fixes first and reuse second.

For: Owners, general managers and chief engineers of hotels, inns and extended-stay properties

A polished silver room-service cloche lid floats upside down at the waterline like a small boat, its handle pointing down below the surface and its dome reflecting soft daylight.

A hotel uses water for many jobs at once: showers, washer extractors, sprinklers, a breakfast kitchen, ice machines, and air handlers dripping condensate. The EPA lists the largest uses of water in hotels as restrooms, laundry operations, landscaping and kitchens. Each has a different fix, and some offer a second use for water the hotel already pays for. Maredes starts with a lab test of the water and a close look at where it goes.

Where the water goes in a hotel

EPA WaterSense’s fact sheet Saving Water in Hotels (2016) splits hotel water use like this:

End use Share of hotel water
Guest rooms and restrooms 30%
Laundry 16%
Landscaping 16%
Kitchen and dishwashing 14%
Cooling and heating 12%
Other 12%
Pools 1%

These are rounded national averages; a property with its own laundry, a pool or a cooling tower can differ widely, so the review builds the split from your bills and equipment. The where hotel water goes tool gives a rough picture first.

Cost follows the meter. In Jackson, JXN Water bills water and sewer together from the meter reading, in blocks that rise with use, so water a hotel stops buying comes off its most expensive block and off the sewer charge. A separate irrigation meter has its own rates.

What usually comes first

  1. Leaks and fixtures. Running toilets and stuck irrigation valves come first. EPA’s hotel fact sheet notes that replacing one pre-rinse spray valve can save a typical commercial kitchen more than 7,000 gallons a year, and that towel and linen reuse programs can cut laundry loads by 17 percent.
  2. Laundry water recycling. In EPA’s laundry guidance, simple recycling reuses the final rinse as the next load’s first rinse, “rarely needs treatment” and saves 10 to 35 percent; complex recycling treats wash and rinse water and can save more than 80 percent. EPA advises involving the chemical supply vendor. See laundry water recycling.
  3. Condensate and rainwater. EPA puts condensate at 3 to 10 gallons per day per 1,000 square feet of air-conditioned space, low in minerals and a good source for cooling tower make-up. The Department of Energy notes that a large amount forms in hot, humid summers such as the southeastern United States, and Jackson averages 57.35 inches of rain a year (NOAA 1991 to 2020 normal). Condensate can grow bacteria, so where people can touch or breathe it, EPA says to filter and disinfect it first. See rainwater and condensate capture.
  4. Greywater for toilet flushing. Only where the building has, or can get, separate drain and supply piping, which is usually a renovation question. See builders and developers and greywater recycling.
  5. Drinking water and ice. Point-of-use treatment for the breakfast kitchen, ice machines and coffee lines, certified to the NSF/ANSI standard for each claim the results support. See drinking water systems.

Reuse water is always non-potable. Maredes does not run chemical treatment programs for cooling towers or boilers.

What a hotel water review looks at

A hotel water review adds these to the bills and building walk:

  • Bills against occupancy, so an odd month stands out.
  • The laundry: pounds per day, washer extractor sizes, the chemical program, hot water and floor space for tanks.
  • Guest rooms: flush volumes and shower flow rates in sample rooms, and a dye test for running toilets.
  • Cooling, roof and grounds: air handlers and the area they serve, condensate drains, any cooling tower, roof area, downspouts and irrigation zones.
  • Kitchen, ice and beverage equipment and any filters already installed.
  • Building water safety. CDC’s Legionella toolkit asks about cooling towers, hot tubs, decorative fountains, height and centralized hot water. CDC calls an effective water management program “the primary strategy to control Legionella growth and spread”. Every Maredes reuse design includes a section for that program’s team; start with the Legionella checklist.

Samples usually come from the kitchen tap, the laundry supply and one condensate drain, analyzed by a certified laboratory.

What you provide and what you receive

You provide: twelve months of water and sewer bills; occupancy by month; laundry pounds per day and the washer list; air-conditioned floor area and roof area; access to the meter, laundry, mechanical rooms and roof; one contact, often the chief engineer; and a decision on the licensed contractor.

You receive: a written review and water balance; certified lab results explained, with the laboratory’s report attached; findings in order of cost; for reuse, a code path memo for the local building official; and, if you continue, drawings, an equipment specification by certification, a bid package, a start-up and verification report and a maintenance log. Licensed plumbing and mechanical contractors install under permits. Engagements explains the options, including a pilot on one washer line or one air handler.

Example: the Pearlbank Hotel

Example (fictional). The Pearlbank Hotel is a fictional 96-room select-service hotel with an on-premise laundry, a small breakfast kitchen, landscaped grounds, central air handlers serving about 50,000 square feet and an 18,000-square-foot roof. At 70% average occupancy it has about 2,043 occupied room-nights a month. Its bills show about 300,000 gallons a month (about 401 CCF), 10,000 gallons on an average day, about 147 gallons per occupied room-night: guest rooms and restrooms 3,000 gallons, laundry 1,600, landscaping 1,600, kitchen 1,400, cooling and heating 1,200 and other 1,200.

The planned design pairs simple laundry rinse recycling (400 gallons a day, 25% of laundry water) with a rain and condensate tank of about 10,000 gallons feeding drip irrigation (about 900 gallons a day usable on average), with filtration and UV because the drip lines run near guest paths. Greywater was screened and not chosen: the building has no separate drain and supply piping. Planned result: 1,300 gallons a day of city water replaced, 13% of supply. At an example combined rate of $26.67 per 1,000 gallons (the top JXN Water block, since the hotel uses about 401 CCF a month), about $12,655 a year avoided, minus an example $2,400 operating cost: about $10,255 net, a 5.9-year simple payback on an example $60,000 installed cost. Every figure is a planning assumption for a fictional hotel. The example project walks through its first 120 days.

Tools to start with

For the Pearlbank’s 50,000 square feet, the condensate calculator shows 150 gallons on a cooling day at the low end and 500 at the high end. The rainwater calculator covers the roof, the water savings calculator prices gallons replaced at your block rate, and the water review checklist lists what to gather.

Start with a water review.

Tell us about the building: what it is, who uses it, where the water comes from and what you would like to change. We reply with questions and a time to walk the building with you.