Laundry water recycling for on-premise laundries
Rinse water reuse for on-premise laundries in hotels, care facilities and laundromats, starting with a feasibility study of simple and complex recycling.
For: Hotels, care facilities, laundromats and other buildings with an on-premise laundry

An on-premise laundry washes much the same linens every day, and after one use most of its water goes to the sewer. Laundry water recycling holds part of that water and uses it again within the wash cycle. It does not leave the laundry: the reused water goes back into the washers, not to toilets or landscaping. Maredes designs and specifies laundry recycling for hotels, care facilities and laundromats, and every design starts with a feasibility study of your machines, loads and chemistry.
When it fits
EPA’s WaterSense at Work guide says on-premise laundries “are typically found in facilities such as hotels, hospitals, nursing homes, prisons, and universities”, with washer extractors that hold 30 to 800 pounds per load. In hotels, EPA’s fact sheet puts laundry at about 16 percent of water use. Recycling fits best where loads are steady every day, the washers have programmable controls, and there is floor space and a drain for a tank.
Cheaper steps come first. EPA notes that towel and linen reuse programs “can help reduce the loads of laundry washed by 17 percent”. When washers are due for replacement, tunnel washers use “2 gallons of water or less per pound” and can reduce water use “by 30 to 60 percent”. The water review ranks these against recycling by cost.
Simple and complex recycling
EPA describes two levels, and the feasibility study compares both.
| Simple recycling | Complex recycling | |
|---|---|---|
| What happens | The final rinse is held in a tank and reused as the next load’s first rinse | Wash and rinse water are collected, treated and returned |
| Treatment | EPA: “rarely needs treatment”; a lint screen | Usually needs treatment equipment |
| Water saved (EPA range) | 10 to 35 percent | More than 80 percent |
| Space | A tank, a pump and controls | Treatment equipment and tanks |
EPA also cites a Pacific Northwest National Laboratory study at a Seattle hotel washing about 280,000 pounds of laundry a month, which found an 80 percent reduction. That is one study of one large laundry, not a forecast for yours. For a mid-size hotel we usually look at simple recycling first, because it needs little treatment and little space.
What it does and does not do
- It does reduce the city water the laundry draws, and the sewer charges billed on the same meter. JXN Water, for example, bills both water and sewer from the water meter.
- It does not send water outside the laundry. Laundry water used for toilets or irrigation counts as greywater and goes through the greywater path instead.
- It does not change wash chemistry by itself, but reused rinse water carries detergent residue and lint. EPA’s guidance is direct: “contact the chemical supply vendor in any retrofit planning”. The study includes your chemical supplier. Maredes does not sell or manage laundry chemicals.
How Maredes designs it
The feasibility study
We gather pounds washed per day and per month, the machine list (make, model, capacity and controls), each wash formula with its fills and gallons, the laundry’s share of the water bill or a sub-meter reading, the hot water supply, the drains, and the floor space. For each formula we map which step’s water could feed which later step. Then we size the tank, usually for a day or less of storage so the water stays fresh, and estimate gallons saved, water and sewer charges avoided at the building’s top rate block, and operating costs. The study can recommend against recycling.
Specification and installation
If the study supports it, the design specifies the tank, pumps, lint screens or filters, level controls and valves, a flow meter on the reuse line so the savings can be measured, and a sample port. City water make-up to the tank goes through an air gap or a backflow preventer, and components on the city supply are certified lead free. Licensed plumbing contractors install it, with electrical work by licensed trades, and permits pulled before work. A short code path memo records who approves the changes and how backflow and labeling are handled.
Example (fictional). The fictional Pearlbank Hotel has 96 rooms at 70 percent occupancy and uses about 10,000 gallons of city water on an average day, of which about 1,600 gallons go to the laundry, using EPA’s hotel shares. The hotel water benchmark shows 23.5 laundry gallons per occupied room-night. The design is simple laundry rinse recycling: each load’s final rinse is held and reused as the next load’s first rinse, saving 25 percent of laundry water, about 400 gallons a day, within EPA’s 10 to 35 percent range. Together with a rain and condensate tank, it is planned to replace 1,300 gallons a day of city water, 13 percent of supply. The full walkthrough is on the example project page. Every figure is a planning assumption.
What you provide and receive
You provide laundry pounds per day, the machine list and wash formulas, your chemical supplier’s contact, twelve months of bills, the floor space available and a laundry supervisor to walk the room with us. You receive a feasibility study that compares simple and complex recycling with a recommendation, including “do not recycle” when the numbers say so. If you continue, you receive the design, specification and bid package, start-up checks and a maintenance plan.
To test the idea first, a pilot system can run simple rinse recycling on one washer line for a fixed term, with written measures and a keep, resize or remove decision at the end. The water savings calculator turns gallons saved into water and sewer charges avoided at your own rate.
Maintenance
Lint screens are cleaned on the manufacturer’s schedule, the tank is inspected and cleaned, level sensors and valves are checked, and reuse flow meter readings are logged. Laundry staff report any change in linen quality, and the chemical supplier rechecks settings after changes. A service plan keeps this on a schedule.
Start with a water review.
Tell us about the building: what it is, who uses it, where the water comes from and what you would like to change. We reply with questions and a time to walk the building with you.